Table of Contents
Advertisement
No.
Designation
6
RS485
7
Network
8
Daisy Chain
In/Out
9
Spot Out
0
Quad Out
Main Out
Option Switch
3
Factory Reset
Switch
4
Power In
NOTES:
• Do NOT connect a cable to the Loop BNC unless it is connected to another device because it will cause
poor quality video.
• To make connections on the Alarm Connector Strip, press and hold the button and insert the wire in the
hole below the button. After releasing the button, tug gently on the wire to make certain it is connected.
To disconnect a wire, press and hold the button above the wire and pull out the wire.
• Camera surveillance may be prohibited by laws that vary by region. Check the laws in your area before
using this product for surveillance purposes.
• Use a STP Cat5E cable which is 5m long or shorter when daisy-chaining MMXs. Using other types of cables
may cause video noise, and the connection of a cable longer than 5m might cause the connection failure.
CAUTIONS:
• The network connector is not designed to be connected directly with cable or wire intended for outdoor use.
• This product is also designed for IT power system with phase-to-phase voltage 230V.
WARNING: ROUTE POWER CORDS SO THAT THEY ARE NOT A TRIPPING HAZARD. MAKE CERTAIN THE POWER
CORD WILL NOT BE PINCHED OR ABRADED BY FURNITURE. DO NOT INSTALL POWER CORDS UNDER
RUGS OR CARPET. THE POWER CORD HAS A GROUNDING PIN. IF YOUR POWER OUTLET DOES NOT
HAVE A GROUNDING PIN RECEPTACLE, DO NOT MODIFY THE PLUG. DO NOT OVERLOAD THE CIRCUIT
BY PLUGGING TOO MANY DEVICES INTO ONE CIRCUIT.
Details
Connect a PTZ camera to control a PTZ camera.
Connect a UTP Cat5 cable with an RJ-45 jack. Refer to the Chapter 6 – Configuration,
6.2 Network, IP Address for details on network setup.
Connect the STP Cat5E cable with an RJ-45 jack to daisy-chain slave MMXs (Out) and a
master MMX (In). See below for more details.
Connect a spot monitor (NTSC or PAL) for monitoring video in single-screen layout.
The cable connection might be different depending on the MMX's operation mode.
Refer to Chapter 4 – Case Installation for details.
Connect a quad monitor (NTSC or PAL) for monitoring video in quad- or single- screen
layout.
Connect a main monitor (NTSC or PAL) for monitoring video in various screen layouts
(A Master MMX Only).
Set the switch to the On (upward) or Off (downward) position depending on the video
signal format, termination or operation mode. Refer to Option Switch for details.
Use only when to return all settings to the original factory settings.
See below for more details.
Connect the power cord to the MMX and then to a wall outlet.
The MMX starts booting when power is applied.
9
Advertisement
Table of Contents
