Eneo MMX Instruction Manual page 16

4. Connect a main monitor to a master MMX through the Main Out port, and quad monitors or spot monitors to
the master MMX and slave MMXs through the Quad Out or Spot Out ports. You can monitor video from any
camera in the main monitor in various layouts, and video from connected MMX on the quad or spot monitors in
the quad- or single-screen layout. Sequence and event monitoring are supported in each monitor.
5. Connect MMXs to network via Ethernet connections through the NETWORK port on the rear panel.
All MMXs should be networked via Ethernet.
6. Run the INIT program and connect to the master MMX. Refer to the INIT User's Manual for details on the
INIT program.
6.. Go to the following menus: Remote Setup
–> Network –> IP Address
Set up the network connection information
of a master MMX and slave MMXs.
The master MMX and slave MMXs' IDs set
by using the MMX ID switch on the rear panel
are displayed in the list (Master MMX ID: 0,
slave MMX ID:  to 63).
6