Spot Monitor - Eneo MMX Instruction Manual

5.3 Spot Monitor

Spot monitors are connected to a master MMX and slave MMXs and controlled by a network keyboard.
You can monitor video from the preset channel in the single screen layout or change a channel to monitor by using a
network keyboard. Sequence monitoring and event monitoring are supported according to the preset settings.
You can also control DVRs by usiing a network keyboard.
NOTES:
• Sequence monitoring allows you to monitor video from user-defined camera channels sequentially.
Camera channels and the sequencing interval should be preset for sequence monitoring.
Refer to Spot Monitor Layout for details of setting up sequence monitoring.
• Event monitoring allows you to monitor event detected video when the user-defined events occur at the
user-defined camera channels. Camera channels and event types should be preset for event monitoring.
Refer to Spot Monitor Layout for details of setting up event monitoring.
• Sequence monitoring and event monitoring are not supported in a spot monitor at the same time.
Spot Monitor Layout
The way to set up the layout on spot monitors is identical to the way to set up the layout on quad monitors.
Refer to Quad Monitor Layout for details.
Controlling Spot Monitor Display
You can change the channel to monitor on the spot monitor or control DVRs connected to MMXs by using a network
keyboard. Refer to the User's Manual of the network keyboard for details on control by the network keyboard.
Event Monitoring
4
Sequence Monitoring