Eneo MMX Instruction Manual page 29

8. Connect spot monitors to the spot MMXs through to the Spot Out ports. You can monitor video from any
cameras on up to four spot MMX monitors at the same time. Sequence and event monitoring are supported in
each monitor. You can also control DVRs connected to the master MMX and slave MMXs.
9. Connect MMXs to network via Ethernet connections through the NETWORK port on the rear panel.
All MMXs should be networked via Ethernet.
0. Run the INIT program and connect to the master MMX.
Refer to the INIT User's Manual for details on the INIT program.
0.. G o to the following menus: Remote Setup
–> Network –> IP Address
Set up the network connection information
of a master MMX and slave MMXs.
The master MMX and slave MMXs' IDs set
by using the MMX ID switch on the rear panel
are displayed in the list (Master MMX ID: 0,
slave MMX ID:  to 63).
9