Event - Eneo MMX Instruction Manual

6.4 Event

You can set up event detection and actions to be taken.
Alarm In
When the MMX senses an input on the alarm input connector, it considers it as an event.
• No.: Select the desired alarm-in devices.
• Title: Click the field and enter the alarm-in device's name.
• Type: Click the field and select the alarm-in type from the drop down list.
• Event Action: Click the field and the Event Action Setup screen appears. Check the box for each action the MMX
will take whenever it detects an alarm-in event.
− Alarm Out: Select to trigger an alarm-output signal.
− Email Callback: Select to send an Email.
− Callback: Select to send a message to remote sites and select the desired remote sites.
− PTZ Preset: Click the desired PTZ camera and select the desired preset number to move a PTZ camera to the
previously saved preset location. You must set up preset locations of PTZ cameras during the PTZ setup on the
DVR or by using the network keyboard.
NOTE: You must properly configure the settings related to each event action during the 5.4 Event – Event
Action setup to enable event actions.
6