Eneo MMX Instruction Manual page 31

.. G o to the following menus: Remote Setup –>
Device –> Setup
Click Digital Video Recorder in the device list and
the Add button to register the DVR connected to the
MMX. You can control the DVRs by using a network
keyboard.
.3. S et up the registration information and click the OK button.
• ID: The network keyboard assigns the ID automatically in
registration order, and you can change the ID. The ID will be used
to distinguish the MMX from other devices when controlling the
MMX by using a network keyboard, so each device should have
its own unique ID.
• Connection: Select Ethernet and enter the IP address, port
numbers (Control Port: Watch port), user ID and password for the
connection to the DVR.
.4. C lick the Digital Video Recorder pull-down menu
in the device list, then the registered DVR's pull-
down menu. A list of monitors and cameras
supported in the DVR is displayed.
[ID] Main Monitor: Displays the monitor ID
•
and type.
[ID] Spot Monitor No.: Displays the monitor ID,
•
monitor type and the Spot Out number of the DVR.
[ID] „Camera Name": Displays the ID and
•
name of the camera.
.5. C lick a camera in the list and the Edit button.
Set up the camera information.
• ID: The network keyboard assigns the ID automatically when the
DVR is registered, and you can change the ID. The ID will be used
to distinguish the camera from other cameras when controlling it
by using a network keyboard, so each camera should have its own
unique ID.
• Type: Set up the camera type.
− Fixed: Select if the camera is not a PTZ camera.
− PTZ Camera: Select if the camera is a PTZ camera and select
the device that controls the PTZ camera.
3