HP 4108GL Management And Configuration Manual page 424

Troubleshooting
Unusual Network Activity
I
None of the devices assigned to one or more VLANs on an 802.1Q-
compliant switch are being recognized. If multiple VLANs are being used
on ports connecting 802.1Q-compliant devices, inconsistent VLAN IDs may
have been assigned to one or more VLANs. For a given VLAN, the same VLAN
ID must be used on all connected 802.1Q-compliant devices.
Link Configured for Multiple VLANs Does Not Support Traffic for One
or More VLANs. One or more VLANs may not be properly configured as
"Tagged" or "Untagged". A VLAN assigned to a port connecting two 802.1Q-
compliant devices must be configured the same on both ports. For example,
VLAN_1 and VLAN_2 use the same link between switch "X" and switch "Y".
Figure 18-1. Example of Correct VLAN Port Assignments on a Link
1.
2.
Duplicate MAC Addresses Across VLANs. The Switch 4108GL operates
with multiple forwarding databases. Thus, duplicate MAC addresses occuring
on different VLANs can appear where a device having one MAC address is a
member of more than one 802.1Q VLAN, and the switch port to which the
device is linked is using VLANs (instead of STP or trunking) to establish
18-12
If the monitor port is not a member of the same VLAN as the traffic from
the monitored ports, traffic from the monitored ports does not go out the
monitor port.
Link supporting VLAN_1
and VLAN_2
Switch "X"
Port X-3
VLAN Port Assignment
Port VLAN_1 VLAN_2
X-3 Untagged Tagged
If VLAN_1 (VID=1) is configured as "Untagged" on port 3 on switch "X",
then it must also be configured as "Untagged" on port 7 on switch "Y".
Make sure that the VLAN ID (VID) is the same on both switches.
Similarly, if VLAN_2 (VID=2) is configured as "Tagged on the link port on
switch "A", then it must also be configured as "Tagged" on the link port
on switch "B". Make sure that the VLAN ID (VID) is the same on both
switches.
Switch "Y"
Port Y- 7
VLAN Port Assignment
Port VLAN_1 VLAN_2
Y-7 Untagged Tagged