Using The Commander To Manage The Stack - HP 4108GL Management And Configuration Manual

HP Procurve Stack Management
HP Procurve Stack Management
4.
5.
6.

Using the Commander To Manage The Stack

The Commander normally operates as your stack manager and point of entry
into other switches in the stack. This typically includes:
I
I
I
I
The Commander also imposes its passwords on all stack members and pro-
vides SNMP community membership to the stack. (See "SNMP Community
Operation in a Stack" on page 13-45.)
13-18
Do one of the following:
• To disable stacking on the Candidate, use the Space bar to select
the Disabled option, then go to step 5.
Note: Using the menu interface to disable stacking on a Candidate
removes the Candidate from all stacking menus.
• To insert the Candidate into a specific Commander's stack:
i. Use the space bar to select Member.
ii. Press [Tab] once to display the
then enter the MAC address of the desired Commander.
• To change
Auto Join
desired parameter, and:
– To change
Auto Join
– To change
Transmission Interval
of 1 to 300 seconds.
Note: All switches in the stack must be set to the same transmis-
sion interval to help ensure proper stacking operation. HP recom-
mends that you leave this parameter set to the default 60 seconds.
Then go to step 5.
press [Enter] to return the cursor to the
Press [S] (for
Save ) to save your configuration changes and return to the
Stacking menu.
Adding new stack members
Moving members between stacks
Removing members from a stack
Accessing stack members for individual configuration changes and traffic
monitoring
Commander MAC Address
or , use [Tab] to select the
Transmission Interval
, use the Space bar.
, type in the new value in the range
line.
Actions
parameter,