Web: Enabling Or Disabling Stp; How Stp Operates - HP 4108GL Management And Configuration Manual

Web: Enabling or Disabling STP

In the web browser interface you can enable or disable STP on the switch. To
configure other STP features, telnet to the switch console and use the CLI.
To enable or disable STP on the switch:
Click on the Configuration tab
1.
2. Click on [Device Features].
3. Enable or disable STP.
Click on [Apply Changes] to implement the configuration change.
4.
For web-based help on how to use the web browser interface screen, click on
the [?] button provided on the web browser screen.

How STP Operates

The switch automatically senses port identity and type, and automatically
defines port cost and priority for each type. The console interface allows you
to adjust the Cost and Priority for each port, as well as the Mode for each port
and the global STP parameter values for the switch.
While allowing only one active path through a network at any time, STP retains
any redundant physical path to serve as a backup (blocked) path in case the
existing active path fails. Thus, if an active path fails, STP automatically
activates (unblocks) an available backup to serve as the new active path for
as long as the original active path is down. For example:
Spanning Tree Protocol (STP)
Web: Enabling or Disabling STP
16-9