Viewing The Switch's Current Cdp Configuration; Viewing The Current Contents Of The Switch's Cdp Neighbors; Table; Contents Of Switch’s Cdp Neighbors Table - HP 4108GL Management And Configuration Manual

Viewing the Switch's Current CDP Configuration

This command lists the switch's global and per-port CDP configuration. (In
the factory default configuration, the switch runs CDP on all ports with a hold
time of 180 seconds and a transmit interval of 60 seconds.)
show cdp
Syntax:
This example shows the default CDP configuration.
CDP Enable/Disable on the Switch
Packet Hold Time in CDP Neighbor Table
Per-Port CDP Enable/Disable
Figure 12-9. Example of Show CDP with the Default CDP Configuration

Viewing the Current Contents of the Switch's CDP Neighbors

Table

This command lists the neighboring CDP devices the switch has detected.
Devices are listed by the port on which they were detected. The entry for a
specific device includes a subset of the information collected from the device's
CDP packet. (For more on this topic, see "CDP Neighbor Data and MIB
Objects" on page 12-25.)
show cdp neigbors [detail]
Syntax:
This example lists six CDP devices (four switches and two workstations) that
the switch has detected by receiving their CDP packets.
Configuring for Network Management Applications
Interval for Transmitting Outbound
CDP Packets on All Ports
CDP
12-19