Web: Viewing And Configuring Vlan Parameters - HP 4108GL Management And Configuration Manual

Port-Based Virtual LANs (VLANs) and GVRP
Port-Based Virtual LANs (Static VLANs)
For example, suppose you have a VLAN named VLAN100 with a VID of 100,
and all ports are set to No for this VLAN. To change the VLAN name to
"Blue_Team" and set ports 1-5 to Tagged, you could do so with these com-
mands:
To move to the vlan 100 context level and execute the same commands:
Similarly, to change the tagged ports in the above examples to No (or Auto, if
GVRP is enabled), you could use either of the following commands.
At the config level, use:
At the VLAN 100 context level, use:
N o t e
You cannot use these commands with dynamic VLANs. Attempting to do so
results in the message "VLAN already exists." and no change occurs.

Web: Viewing and Configuring VLAN Parameters

In the web browser interface you can do the following:
I
I
I
I
I
To configure static VLAN port parameters, you will need to use the menu
interface (available by Telnet from the web browser interface) or the CLI.
1.
2.
14-22
(For information on dynamic VLAN and GVRP operation, see "GVRP" on
page 14-30.)
- or -
Add VLANs
Rename VLANs
Remove VLANs
Configure GVRP mode
Select a new Primary VLAN
Click on the Configuration tab.
Click on [VLAN Configuration].