HP 4108GL Management And Configuration Manual page 148

Time Protocols
TimeP: Viewing, Selecting, and Configuring
For example, suppose:
I
I
The commands and output would appear as follows:
Figure 8-15. Example of Enabling TimeP Operation in DHCP Mode
Enabling Timep in Manual Mode. Like DHCP mode, configuring TimeP for
Manual
specify the IP address of the TimeP server. (The switch allows only one TimeP
server.) To enable the TimeP protocol:
Syntax:timesync timepSelects Timep.
ified TimeP
N o t e
To change from one TimeP server to another, you must (1) use the no ip timep
command to disable TimeP mode, and then reconfigure TimeP in Manual
mode with the new server IP address.
8-18
Time synchronization is configured for SNTP.
You want to:
1.View the current time synchronization.
2.Select TimeP as the time synchronization mode.
3.Enable TimeP for DHCP mode.
4.View the TimeP configuration.
1 show timep displays the TimeP configuration and also shows
that SNTP is the currently active time synchronization mode.
2
3
4 show timep again displays the TimeP configuration and shows that TimeP is
now the currently active time synchronization mode.
mode enables TimeP. However, for manual operation, you must also
ip timep manual <ip-addr>Activates TimeP in Manual mode with a spec-
server.
no ip timepDisables TimeP.