HP 4108GL Management And Configuration Manual page 299

Syntax:
In the destination Commander, use show stack all to find the MAC address of
the Member you want to pull into the destination stack. For example, suppose
you created a new Commander with a stack name of "Cold_Waters" and you
wanted to move a switch named "Bering Sea" into the new stack:
Figure 13-32. Example of Stack Listing with Two Stacks in the Subnet
You would then execute the following command to pull the desired switch
into the new stack:
Since a password is not set on the Candidate, a password is not needed in this
example.
You could then use
Using a Member CLI To "Push" the Member into Another Stack. You
can use the Member's CLI to "push" a Switch 4108GL stack Member into a
destination stack if you know the MAC address of the destination Commander.
Syntax: stack join <mac-addr>
Converting a Commander to a Member of Another Stack. Removing
the Commander from a stack eliminates the stack and returns its Members to
the Candidate pool with
stack member <switch-number>
mac-address <mac-addr>
[password<password-str>]
Where is an unused switch number (
1
show stack all
where: <mac-addr> is the MAC address of the Commander for the desti-
nation stack.
Auto Join
HP Procurve Stack Management
HP Procurve Stack Management
Move this switch into the "Cold Waters" stack.
).
SN
again to verify that the move took place.
disabled.
13-41