Parts Names And Functions - Sanyo VCC-ZM500P Installation Manual

Parts Names and Functions

Rear panel
1
VIDEO OUT connector (BNC type)
Outputs video signal.
Connect this terminal to the video input terminal
of the external device.
2
Control terminals (Push-lock)
Used to perform the control functions such as
controlling the camera remotely or inputting/
outputting alarm.
(A) ALARM IN 1/2 terminal
<Alarm input terminal>
Used to connect the alarm device that
detects intruders.
Connect this terminal to an external alarm
switch or an infrared sensor, etc.
(B) ALARM OUT terminal
Used to connect to an external buzzer or
lamp.
When an alarm is detected, the device
connected to the terminal notifies that an
alarm is detected.
(C) COM terminal (earth terminal)
(D) FOCUS terminal
Used to perform the focus adjustment
remotely by connecting an external switch.
• DC ± (6 - 12 V), +: FAR, –: NEAR
(E) ZOOM terminal
Used to zoom in/out by connecting an
external switch.
• DC ± (6 - 12 V), +: WIDE, –: TELE
POWER lamp
POWER
VIDEO OUT
1
2
b Push-lock
When connecting the cable, press and hold
down the protrusion of the terminal, insert the
cable into the terminal, and then release the
protrusion.
3
(a) (b)
A B COM
N.C.
RS485
3
A B COM
N.C.
RS485
AC24V
GND
DC12V
(A)
(B)
(C)
(D)
(E)
4