Parts Names and Functions
■
Rear
①
④
POWER
③
GND
CLASS 2 WIRING
① Flange back fixing screw
② Flange back adjustment lever
③ AC24V / DC12V terminals
Connect this terminal to the power supply.
•
When the camera is turned on, the POWER
lamp lights.
④ Power lamp
■
Side
①
②
⑤
ALARM OUT
VIDEO OUT
ALARM IN
COM
LAN
LINK
⑨
②
③
⑤ Lens terminals
⑥ VIDEO OUT connector (BNC type)
Used to output image signals.
Connect to video equipment such as a
monitor.
⑦ Control terminals
⑥
When connecting the cable, press and hold
down the protrusion of the terminal, insert the
cable into the terminal, and then release the
⑦
protrusion.
•
COM terminal (Earth terminal)
⑧
•
ALARM IN terminal
Connect to a device such as an external
alarm switch or an infrared sensor.
•
ALARM OUT terminal
Used to connect to an external buzzer or
lamp.
When an alarm is detected, the device
connected to the terminal notifies that an
alarm is detected.
⑧ LAN connector (RJ-45)
Used to connect the camera to your network.
⑨ LINK lamp
When connected correctly to the network, the
lamp will illuminate 3 seconds after the power
is turned on.
Flashes while data is being transferred.
① Camera setting switches (P7)
② White balance manual adjustment
controls
R: Red adjustment
B: Blue adjustment
④
③ Iris adjustment control (LEVEL)
This can only be adjusted when using a DC-
type automatic iris lens.
④ Reset button (RESET)
If pressed for approximately 5 seconds, it
initializes the various NETWORK SETTINGS
settings (such as IP address) for network
operations.
5