Parts Names And Functions - Sanyo VCC-ZM600P Installation Manual

Parts Names and Functions

Rear panel
1
VIDEO OUT connector (BNC type)
Outputs video signal.
Connect this terminal to the video input terminal
of the external device.
2
Control terminals (Push-lock)
Used to perform the control functions such as
controlling the camera remotely or inputting/
outputting alarm.
1
ALARM IN 1/2 terminal
These terminals can be used as an input
terminal for either of the following functions.
<Alarm input terminal>
Used to connect the alarm device that
detects intruders.
Connect this terminal to an external alarm
switch or an infrared sensor, etc.
<Day/Night function terminal>
Used to switch the viewing mode manually
between the color mode and the black/white
mode.
To do so, select [DAY/NIGHT], choose
"COLOR", and set the [EXT ALARM] to the
desired alarm input channel.
2
ALARM OUT terminal
Used to connect to an external buzzer or
lamp.
When an alarm is detected, the device
connected to the terminal notifies that an
alarm is detected.
3
COM terminal (earth terminal)
4
FOCUS terminal
Used to perform the focus adjustment
remotely by connecting an external switch.
• DC ± (6 - 12 V), +: FAR, –: NEAR
5
ZOOM terminal
Used to zoom in/out by connecting an
external switch.
• DC ± (6 - 12 V), +: WIDE, –: TELE
POWER lamp
POWER
VIDEO OUT
1
2
b How to use the push-lock switch
When connecting the cable, press and hold
down the protrusion of the terminal, insert the
cable into the terminal, and then release the
protrusion.
3
1 2 3
A B COM
RS485
UTP
3
A B COM
RS485 UTP
AC24V
GND
DC12V
1
2
3
4
5
4