Drive Roller - Landice L-10 Service Manual

Drive Roller Removal & Installation:
INTRODUCTION: This document is to be used for the installation and removal of the Front (Drive)
Roller (#10028).
TOOLS REQUIRED:
BEFORE YOU BEGIN
side frame cover to gain access to the drive roller. Please refer to the instructions for both
Removal and Side Frame Removal
A
Using a ½" socket wrench, loosen and remove the front roller adjustment bolt, as shown in
A. Remove the bolt, washer and spring, and then remove the J-hook. Using a 5mm Allen Wrench,
loosen and remove the bolt holding the drive motor in place, as shown in
With the bolts on both sides removed, you will need to remove the drive belt next. Work it slowly off the drive
motor shaft, being careful not to damage the belt. You can then lift the drive roller out of the left side insert
5mm Allen Wrench

½" Socket Wrench

 Socket Wrench
You will need to remove the motor cover, upright end cover caps, and
:
if you need assistance.
Step 1
Step 2
and remove the drive belt from the roller.
B
Motor Cover
Illustration
Illustration B.
33