Polycom SpectraLink 8020 Administrator's Manual page 131

Message Description
Incorrect Security settings.
No Net Found x...x = AP MAC address.
xxxxxxxxxxxx yy yy = AP signal strength.
Handset cannot find a suitable AP;
displays MAC and signal strength of
"best" non-suitable AP found.
No Net Found The Wireless Telephone is configured
No CCX APs for CCX compatible operation, but
cannot find an access point that is
advertising CCX capability.
No Net Found The Wireless Telephone is configured
No CCKM APs to use CCKM for fast and secure
handoffs, but cannot find an access
point that is configured appropriately.
No Net Found The Wireless Telephone is configured
No WMM APs to use Wi-Fi Standard QoS, but cannot
find an AP configured appropriately.
No PBX Response The handset has exceeded its
retransmission limit with no ACK
response from proxy server.
No Reg Domain Regulatory Domain Not Set.
No Server IP In the case of static IP configuration,
the handset failed to find the call
server IP.
No SIP TFTP IP No IP address has been entered for
the SIP TFTP server.
The phone is attempting to download a
No SIP user file
SIP configuration file from the SIP
TFTP server. A file must be available
for the username that was entered
either in the Admin menus or as
requested at power-on.
No SVP IP The handset is configured for "Static
IP" (as opposed to "use DHCP"), and
no valid SpectraLink 8000 SVP Server
address has been entered.
PN: 1725-36038-001-H.doc
Action
Verify that all the Security settings in the
handset match those in the APs.
Check AP and handset network settings
such as ESSID, Security, Reg domain
and Tx power.
Ensure APs are configured per
Configuration Guide.
Try Site Survey mode to determine a
more specific cause.
Check the AP configuration against
VIEW Configuration Guide for AP.
Check the AP configuration against
VIEW Configuration Guide for AP.
Check the AP configuration against
VIEW Configuration Guide.
Verify that proxy server IP address and
port are properly configured.
Configure the Regulatory Domain of the
handset.
Verify that call server info is properly
configured on the handset.
In static IP mode the SIP TFTP server
address must be entered in the
administrative menus.
Ensure a SIP configuration file is
available on the SIP TFTP server and is
named as specified (sip_username.cfg).
Enter a valid SpectraLink 8000 SVP
Server IP address in the configuration
setting or change to "use DHCP."
Troubleshooting
131