Polycom SpectraLink 8020 Administrator's Manual page 128

SpectraLink 8020/8030 Wireless Telephone: Administration Guide for SIP
Message Description
DHCP Error 2.
DHCP Error 3.
DHCP Error 4.
DHCP Error 5.
DHCP Lease Exp y...y = DHCP server IP address.
yyy.yyy.yyy.yyy
DHCP is not responding to renewal
attempts (at least one renewal
succeeded).
DHCP NACK error y...y = DHCP server IP address.
yyy.yyy.yyy.yyy DHCP server explicitly refused
renewal.
DL Not On Sector Handset software download files are
incorrect or corrupted.
DO NOT POWER The handset is in a critical section of
OFF the software update.
Duplicate IP The handset has detected another
device with its same IP address.
Erase Failed Download process failed to erase the
memory in the handset.
128
Action
The handset has not received a
response from the server for a request
to an IP address. It will retry until a
server is found.
The server refuses to lease the handset
an IP address. It will keep trying.
The server offered the handset a lease
that is too short. The minimum lease
time is 10 minutes but Polycom
Engineers recommend at least one-
hour minimum lease time. The handset
will stop trying. Reconfigure the server
and power cycle the handset.
Failure during WEP Key rotation
process (proprietary feature).
The handset failed to renew its DHCP
lease, either because the DHCP server
is not running, or because the
configuration has been changed by the
administrator. The handset will attempt
to negotiate a new lease, which will
either work, or it will change to one of
the above DHCP errors (1 through 4).
The DHCP lease currently in use by the
handset is no longer valid, which forces
the handset to restart. This problem
should resolve itself on the restart. If it
does not, the problem is in the DHCP
server.
Download new software from the
Polycom website per Software
Maintenance.
None. Do not remove the Battery Pack
or attempt to power off the phone while
this is displayed. Doing so may require
the handset inoperable.
If using DHCP, check that the DHCP
server is properly configured to avoid
duplicate addresses.
If using Static IP, check that the
handset was assigned a unique
address.
Operation will retry but may eventually
report the error "int. error: 0F" Power
cycle the handset.
PN: 1725-36038-001-H.doc