Installing Options - Tektronix Phaser 600 Service Manual

2
Installing the Printer and Drivers

Installing options

2-18 Phaser 600 Color Printer
Caution To keep your printer in good working order, always use clean,
unused media.
1. Installing RAM SIMMs
includes 8 Mbytes of RAM. This can be supplemented with 16-Mbyte
RAM SIMMs. To install the optional memory, refer to the Chapter 8
topic, "RAM SIMM" on page 8-65.
2. Installing a network card
optional PhaserShare Network Interface plug-in cards.
The LocalTalk/Serial Card supports AppleTalk/LocalTalk protocols
and RS-232 serial connectors.
The Ethernet Interface Card supports the EtherTalk, Novell NetWare,
and TCP/IP protocols.
The Token Ring Network Card supports Novell NetWare, TokenTalk
and TCP/IP protocols.
To install a network card, refer to the Chapter 8 topic, "Network card"
on page 8-68.
3.
Following RAM SIMM or network card installation, turn on the
printer, as explained in the following topics, to ensure that the card
works properly. The printer executes a power-up self-test and prints a
startup page. If the printer fails its self-test, refer to Chapter 6,
"Troubleshooting." The printer can take up to 15 minutes to warm up
from a cold start.
4.
Connect the printer to a host as detailed in the following topics.
Note Carry spare serial and parallel cables and network adapters.
You can use them if you encounter a defective cable or as an alternate
means of testing the printer-to-host communications.
. The standard configuration of the printer
. Network support is provided via three