Users Safety Summary - Tektronix Phaser 600 Service Manual

Color printer
Hide thumbs Also See for Phaser 600:
Table of Contents

Advertisement

Users safety summary

Terms in manual:
CAUTION
WARNING
Power source: Do not apply more than 250 volts RMS between the supply conductors or between either supply
conductor and ground. Use only the specified power cord and connector. Refer to a qualified service technician for
changes to the cord or connector.
Operation of product: Avoid electric shock by contacting a qualified service technician to replace fuses inside the
product. Do not operate without the covers and panels properly installed. Do not operate in an atmosphere of
explosive gases.
WARNING
Safety instructions: Read all installation instructions carefully before you plug the product into a power source.
Terms on product:
CAUTION
DANGER
Care of product: Disconnect the power plug by pulling the plug, not the cord. Disconnect the power plug if the
power cord or plug is frayed or otherwise damaged, if you spill anything into the case, if product is exposed to any
excess moisture, if product is dropped or damaged, if you suspect that the product needs servicing or repair, and
whenever you clean the product.
Ground the product: Plug the three-wire power cord (with grounding prong) into grounded AC outlets only. If
necessary, contact a licensed electrician to install a properly grounded outlet.
Symbols as marked on product:
DANGER high voltage:
Protective ground (earth) terminal:
Use caution. Refer to the manual(s) for information:
!
WARNING: If the product loses the ground connection, usage of knobs and controls (and other conductive parts) can
cause an electrical shock. Electrical product may be hazardous if misused.
Conditions that can result in damage to the product.
Conditions that can result in personal injury or loss of life.
Turning the power off using the On/Off switch does not de-energize the printer.
You must remove the power cord to disconnect the printer from the mains. Keep
the power cord accessible for removal in case of an emergency.
A personal injury hazard exists that may not be apparent. For example, a panel
may cover the hazardous area. Also applies to a hazard to property including the
product itself.
A personal injury hazard exists in the area where you see the sign.

Advertisement

Table of Contents
loading

Table of Contents