Image processor board
1.
Turn off the printer. Leave the power cord plugged in to provide a
discharge path for static electricity.
2.
Disconnect all host interface cables and SCSI cables from the rear of
the image processor board.
3.
Remove the six screws securing the image processor board to the rear
of the printer's card cage.
4.
Slide out the image processor board.
Figure 8-49 Removing the image processor board
Reverse these steps to install the image processor board.
Field Replaceable Unit Disassembly/Assembly
g p
Card cage
board
Remove
six screws
Service Manual
8-63
8