Tektronix Phaser 600 Service Manual page 211

Fuser belt
7.
Flip up the tension adjust screws to loosen the tension on the fuser
belt.
8. Unhook each end of the fuser belt from the fuser shuttle. Remove the
belt.
Figure 8-30 Unhooking the fuser belt
Reverse these steps to reinstall the fuser belt and the fuser. Note the pin on the
right print engine frame to support the fuser as you install it. Set the fuser on the
pin and tilt it up into place. Ensure the fuser is properly aligned to the lower
roller guide as explained in the Chapter 9 topic, "Lower roller guide alignment"
on page 9-9. Also ensure the fuser belt is properly tensioned to 0.5 kgs (1 lb.) as
explained in the Chapter 9 topic, "Fuser belt tension" on page 9-6.
Field Replaceable Unit Disassembly/Assembly
Fuser
shuttle
Service Manual
8
Flip up tension
adjuster to release
belt tension
Adjusting
screws
9482-52
8-39