Drip Plate - Tektronix Phaser 600 Service Manual

Drip plate

Tools required
#1 POSIDRIV® screwdriver
1. Turn off the printer. Leave the power cord plugged in to provide a
discharge path for static electricity. Allow the drip plate to cool; this
takes about 10 minutes.
2. Remove the right cover as explained in the earlier procedure, "Right
cover" on page 8-4.
Warning The printhead, maintenance station and drip plate may still be hot.
To avoid injury, allow them to cool before touching them.
3. Move the printhead to the left, away from the printhead's home
position.
4. To create more working room, you can remove the maintenance
station as described in the previous procedure.
5. Disconnect the drip plate wiring harness from the interconnect board
on the side of the printer frame.
6. Carefully remove the C-clips close to the drip plate securing the drip
plate rods.
Field Replaceable Unit Disassembly/Assembly
Small needle-nose pliers
Service Manual
8
8-23