Turning On The Printer - Tektronix Phaser 600 Service Manual

2
Installing the Printer and Drivers

Turning on the printer

2-22 Phaser 600 Color Printer
Caution
Before turning on the power to the printer, make sure that you have
removed the shipping block (printhead restraint) from inside the
printer's top cover. Otherwise the printer will power-up with an
error.
After you have connected all the interface cables, you are ready to connect the
power cord and turn on the printer.
Caution
To protect your printer from a power surge, make sure that the
power switch on the printer is in the off position before plugging in
the cord.
Make sure that you use the power cord that is shipped with the printer.
1. Plug the power cord into the printer and into a grounded outlet.
Figure 2-17 Attaching the power cord
2. Turn on the power to any peripherals you have connected (such
as a font disk or Phaser Copystation).
3.
Wait 1 minute, then turn on the printer.
9480-10