Right Cover - Tektronix Phaser 600 Service Manual

8
Field Replaceable Unit Disassembly/Assembly

Right cover

8-4 Phaser 600 Color Printer
1.
Remove the waste bin using the menu item Utilities — Unlock Waste
Bin.
2. Turn off the printer. Leave the power cord plugged in to provide a
discharge path for static electricity.
3. Remove the three screws securing the right roll cover end cap.
Remove the end cap.
4. Remove the four screws securing the right cover in place. Spread the
bottom of the cover and lift to remove it.
5. With the cover raised, disconnect the front panel ribbon cable from the
front panel on the inside of the right cover. Also, free the ribbon cable
from the inside of the right cover.
Note The ribbon cable features enough extra length to remain connected to
the front panel while the right cover is removed to assist
troubleshooting the printer.
End cap screws
Right
end cap
Cover screws
Figure 8-3 Removing the right cover
Reverse these steps to reinstall the right cover.
Right cover
Cover screws
9482-26