Sanyo DSR-5016 Instruction Manual page 48

5 SEARCHING FOR RECORDED VIDEO
(3) Turn the jog dial to set the end date and time for motion
sensing (i.e., 8 PM on the same day) and then turn the
shuttle dial clockwise.
The cursor moves to "MOTION SENSOR".
Set the
end date
and time.
2
Turn the shuttle dial clockwise.
The motion sensor setting screen is displayed.
Use the following procedure to set to detect a given range with
the motion sensor.
(1) Turn the jog dial to move the starting position to the
desired detection range and then turn the shuttle dial
clockwise.
" " changes to a yellow " ".
(2) Turn the jog dial to move left and right.
(3) Press the [FUNC.] button.
Cursor movements can be changed from left and right to
up and down.
FUNC.
(4) Turn the jog dial to move up and down.
English
< MOTION DETECTION SEARCH >
SEARCH FROM : NORMAL / CHANNEL : --
START :
09-12-03 10:00
END :
09-12-03 20:00
MOTION SENSOR ->
PREVIEW ->
VIEW ->
MOVE:JOG SELECT:SHUTTLE
LEVEL:OFF EXIT
LEVEL:OFF EXIT
(5) Turn the shuttle dial clockwise.
The yellow areas change to gray.
3
Turn the jog dial to select "LEVEL" and
then turn the shuttle dial clockwise.
"OFF" flashes.
4
Turn the jog dial to select sensitivity
and then turn the shuttle dial clockwise.
After the sensitivity level is set, the cursor moves to "EXIT".
[Settings] ( indicates default setting)
Setting
OFF Motion sensing is not performed.
Motion sensing is performed. Lower
1 to 10 numbers correspond to higher levels of
sensitivity.
5
Turn the shuttle dial clockwise.
The display returns to the <MOTION DETECTION SEARCH>
screen.
47
LEVEL:OFF EXIT
LEVEL:OFF EXIT
LEVEL:OFF EXIT
Description
< MOTION DETECTION SEARCH >
SEARCH FROM : NORMAL / CHANNEL : --
START :
09-12-03 10:00
END :
09-12-03 20:00
MOTION SENSOR ->
PREVIEW ->
VIEW ->
MOVE:JOG SELECT:SHUTTLE