Sanyo DSR-5016 Instruction Manual page 13

2 NAMES AND FUNCTIONS OF PARTS
12. SENSOR ALARM OUT terminals
The terminals are used when motion sensors have been set
( P.99) to output an alarm signal to a connected device upon
detection of motion.
Pin
C Ground
Output of an alarm signal for
SENSOR ALARM OUT 1
Camera No. 1
Output of an alarm signal for
SENSOR ALARM OUT 2
Camera No. 2
Output of an alarm signal for
SENSOR ALARM OUT 3
Camera No. 3
Output of an alarm signal for
SENSOR ALARM OUT 4
Camera No. 4
Output of an alarm signal for
SENSOR ALARM OUT 5
Camera No. 5
Output of an alarm signal for
SENSOR ALARM OUT 6
Camera No. 6
Output of an alarm signal for
SENSOR ALARM OUT 7
Camera No. 7
Output of an alarm signal for
SENSOR ALARM OUT 8
Camera No. 8
Output of an alarm signal for
SENSOR ALARM OUT 9
Camera No. 9
Output of an alarm signal for
SENSOR ALARM OUT 10
Camera No. 10
Output of an alarm signal for
SENSOR ALARM OUT 11
Camera No. 11
Output of an alarm signal for
SENSOR ALARM OUT 12
Camera No. 12
Output of an alarm signal for
SENSOR ALARM OUT 13
Camera No. 13
Output of an alarm signal for
SENSOR ALARM OUT 14
Camera No. 14
Output of an alarm signal for
SENSOR ALARM OUT 15
Camera No. 15
Output of an alarm signal for
SENSOR ALARM OUT 16
Camera No. 16
13. Control terminals
2ND RS485/422 A
2ND RS485/422 B
Signal
C
REMOTE R1
REMOTE R2
CLOCK IN
CLOCK OUT
EXT TIMER IN
ALARM OUT
ALARM RESET
NON REC OUT
WARNING OUT
FULL
ARCHIVE FULL
C
14. [ALL RESET] button
When the [ALL RESET] button is pressed, the digital video
recorder is reset and the time is returned to its default setting.
15. Expansion unit connection terminal
Used to expand the hard disk. Cannot be used together with
RAID unit.
Please contact the dealer for details. When handling and
connecting, be sure to read the instruction manual included
wtih the external storage unit.
16. USB terminal
Connects to a recordable CD or DVD drive. For compatibility,
refer to the SANYO homepage.
http://www.sanyosecurity.com/
The rear panel and front panel USB terminals cannot be
connected to simultaneously.
17. LAN terminal (10BASE-T/100BASE-TX)
Connect to switching hubs, routers and PCs.
18. RS-485 termination switch
Used when connecting multiple devices from the RS-485
control connectors.
19. RS-485 control connectors (A) (B)
Connects to a system controller or dome cameras.
20. RS-232C terminal
Connects to a modem.
21. AC power socket (AC IN)
Insert the supplied power cord securely into this socket.
22. Power cord holder
Secure the power card to the holder using the power cord tie
(accessory) as shown in the illustration.
12
Pin Signal
Control terminal (A)
Control terminal (B)
Ground
Remote input 1
Remote input 2
Clock adjust input terminal
Clock adjust output terminal
External timer input terminal
Alarm output terminal
Cancels alarm
Non-recording output
HDD or FAN error warning output
Capacity warning output for
recording area
Capacity warning output for archive
area
Ground
English