Sanyo DSR-5016 Instruction Manual page 102

2 RECORD SET
To specify the start position and end position
together within a range
(1) Turn the jog dial to move the cursor (blue) to the start
position and then turn the shuttle dial clockwise.
(2) Turn the jog dial to select "A" or "B" and then turn the
shuttle dial clockwise. ("A" or "B" are yellow.)
(3) Turn the jog dial to move the cursor (blue) to the end
position and then turn the shuttle dial clockwise.
Start position
End position
Setting time periods
11
Turn the jog dial to select "T-1" and
then turn the shuttle dial clockwise.
"T-1" flashes.
12
Turn the jog dial to select the time
period and then turn the shuttle dial
clockwise.
The cursor moves to "LEVEL".
[Settings] ( indicates default setting)
Setting
T-1 Time period T-1
T-2 Time period T-2
T-3 Time period T-3
T-4 Time period T-4
English
A A A A
A A A A
A A A A A A A A
A A A A
A A A A
CH01 T-1 LEVEL : OFF MODE : A
A
CH01 T-1 LEVEL : OFF MODE : A
A
CH01 T-1 LEVEL : OFF MODE : A
Description
101
Setting sensitivity levels
13
Turn the shuttle dial clockwise.
"OFF" flashes.
14
Turn the jog dial to select "OFF" or a
sensitivity level between "1" to "10" and
then turn the shuttle dial clockwise.
The cursor moves to "MODE".
[Settings] ( indicates default setting)
Setting
OFF Motion sensing is disabled.
Motion sensing is enabled. Lower numbers
1 to 10
correspond to higher levels of sensitivity.
Setting sensor modes
15
Turn the shuttle dial clockwise.
"A" flashes.
A
CH01 T-1 LEVEL : OFF MODE : A
A
CH01 T-1 LEVEL : OFF MODE : A
Description
A
CH01 T-1 LEVEL : OFF MODE : A