Configuring Ptz Cameras; Configuring Basic Ptz Settings - HIKVISION DS-9000 Series User Manual

Configuring PTZ Cameras
Configuring Basic PTZ Settings
Settings for a PTZ camera must be configured before it can be used. Before proceeding, verify that the PTZ and RS‐485 of
the DVR are connected properly.
To configure PTZ settings:
Enter the PTZ Configuration menu, shown in Figure 41 by going to Main Menu > System Configuration > PTZ
1.
Configuration.
Select the Serial Settings tab.
2.
Select the camera to configure in the camera drop down menu on the upper left of the menu. If all cameras are to
3.
be configured with the same settings, select All Cameras from the list.
Configure PTZ settings, including those of Baud Rate, Data Bit, Stop Bit, Parity, Flow Ctrl, Protocol and Address
4.
according to the parameters of the PTZ camera(s).
Click the Save button to save current settings.
5.
Figure 41. PTZ Configuration Menu
48