Complete The Installation; Initial Lighting / Seasonal Heat Dump Adjustment / Replace The Glass Assembly / Install The Lower Grill - kozy heat Jackson 911 Installation And Operation Manual

K) COMPLETE THE INSTALLATION
1. THIS STEP SHOULD ONLY BE DONE BY A QUALIFIED INSTALLER OR SERVICE TECHNICIAN:
A) Perform lighting and shutdown procedures as described on pages #25-26. This should be done prior to replacing the glass so
that any necessary adjustments can be made and proper operation and log position verified.
2. SEASONAL HEAT DUMP ADJUSTMENT:
This fireplace insert has been manufactured with a heat vent damper located at the top inside the firebox. This allows infinite control over
the amount of heat emitted into the living area without affecting the flame height.
INSTALLER: Please install the fireplace insert with the heat vent damper in the closed position.
HOMEOWNER: The fireplace has been installed with the heat dump in the closed position and will operate at its peak efficiency. The heat
dump may be opened as much as necessary to maintain desired heat level.
TO ADJUST:
CAUTION: DO NOT ATTEMPT TO ADJUST THE HEAT DUMP OPENING IF THE FIREPLACE HAS BEEN IN OPERATION. ALLOW AMPLE
TIME TO COOL OR USE THE APPROPRIATE PROTECTION TO AVOID SERIOUS BURNS AND/OR PROPERTY DAMAGE.
A. Remove the glass assembly & open or close the damper as desired.
HEAT OUTLET
SHOWN IN CLOSED
POSITION.
3. Replace the glass / black frame assembly. Refer also to Figure K-1.
WARNING: DO NOT OPERATE THIS FIREPLACE WITH THE
GLASS ASSEMBLY REMOVED, CRACKED, OR BROKEN.
Replacement of the glass assembly should be done by a
licensed or qualified service person.
A. Align the 3 slots in the top of the glass assembly
over the 3 tabs on the fireplace (at the top).
Place the glass assembly so it is flush with the front of the fire-
B.
place front.
C. While holding the glass assembly, pull the latches out and se-
cure over the glass latch clips on the bottom of the glass frame
locking it in place.
Install the lower grill. Refer to Figure K-2.
4.
A. Place the bolts through the hinges in the lower grill opening.
B. Attach the 1/4" nuts.
C. Tighten both 1/4" nuts.
Figure K-1
Figure K-2
PAGE 23
HEAT OUTLET SHOWN IN
IN PARTIAL OPENED
POSITION.