Oce VarioPrint 1105 Review Manual page 18

Océ VarioPrint 1105
Device Management
The box menu allows
users to view, manage
and reprint jobs stored in
the user boxes on the
device hard drive. Jobs
can be stored within a
user box either from the
desktop using the print
to user box function in
the printer driver, or
scanned directly into a
user box using the
document scanner.
Once the user has
selected the job they
wish to reprint, the user
can specify all the print
job settings before
resubmitting the job into
the queue. This is a valuable feature
allowing CRD/print shop operators to store
commonly used documents for fast
reprinting without having to go through the
RIP process on the files again.
We would have liked to have had the ability
to view files stored in the box, if only
thumbnail view so we
could ensure that the
correct file had been
selected before
committing to a new print
run.
Having said that, we
could choose to send the
job in the proof and print
mode, where a single set
of the job is output,
allowing the operator to
cancel the job if any
settings are incorrect, or
simply release the
remaining sets into the
job queue if all is well
and good.
Copyright © 2008 BERTL Inc. All Rights Reserved. The license under which this document is made available and applicable law prohibit any reproduction or further
transmission of any portion of this document. This document may only be viewed electronically through the www.BERTL.com Web site and may not be stored in electronic
or hard copy format. Any reproduction of trademarks is strictly prohibited. BERTL accepts no responsibility for any inaccuracies or omissions contained in this document.
Above: Choosing a job stored in a user box
Below: Setting up the print parameters
March 2008