Installing The Batteries; Using The Remote Control; Connections; Connecting To Your Aerial Antenna - Strong SRT 8525 User Manual

PART 2 • English
23. :
24. "
25. 4
26. 1
27. 5
28. 6
29. 3

2.4 Installing the batteries

Open the cover on the remote control and insert 2x AAA batteries into the compartment.
Correct position of the polar diagram shows the batteries inside the compartment.
1. Open the cover 2. Insert the batteries
WARnIng:

2.5 Using the remote control

To use the remote control, point it towards the front of your receiver. The remote control supports a
range of up to 7 meters distance to the receiver at an angle of up to approx. +-30 degrees.
noTE:

3.0 ConnECTIons

WARnIng:

3.1 Connecting to your aerial antenna

To receive digital broadcast signals, your receiver has to be connected to a terrestrial indoor or outdoor
antenna. Use the antenna cable to connect the aerial with the ANT IN connector on the back of your
receiver. Please ensure that a properly shielded antenna cable and suitable connectors are used.
The TO TV connector allows you to loop the antenna signal to a second receiver or TV set.

3.2 Connecting to Tv with hDmI cable

We recommend connecting your TV set with the receiver using a good quality HDMI 1.3 or higher
cable (not included). This connection supports the highest possible quality.
For multimedia playback: to start playback of the previous file
For multimedia playback: to start playback of the next file
No function
For multimedia playback: to start playback
For multimedia playback: starts fast rewind, supported modes
are: 2x, 4x, 8x, 16x and 32x
For multimedia playback: starts fast forward, supported modes
are: 2x, 4x, 8x, 16x and 32x
For multimedia playback: to stop playback of a file
3. Close the lid
The batteries should not be recharged, disassembled, electrically short-
circuited, be mixed or used with other types of batteries. If rechargeable
accumulators will be used instead of batteries, we recommend using (e.g.
NiMH) types with low self-discharge to ensure long time operation of the
remote control.
Managing the receiver will be limited or not possible if there are obstacles
between the remote control sensor (at the front panel of the receiver)
and the remote control. Direct sunlight or very bright light can reduce or
disturb the reception of the remote control signals.
Please make sure that connection devices are disconnected from their
main power supplies before connecting these to the receiver.
Fig. 4
Fig. 5
Fig. 6
Fig. 6
5