Channel Search - Strong SRT 8525 User Manual

By Service Name:
By Frequency:
By Operator:
6.1.3 Delete All
Use this menu carefully! It will delete all of the stored channels and settings! To execute this function
it will be requested to enter the PIN code (DEfAUlT PIn: 0000). After you have performed this
action you will be guided to the Installation Guide again!
WARnIng:

6.2 Channel search

In the menu Channel Search you can adjust your search settings and perform an automatic
or manual channel search. Press mEnU and use tu to select Channel Search, then press ok.
Following submenus will be displayed: Search Setup, Auto Search and Manual Search.
Use pq to select a submenu and press ok or u to access.
6.2.1 search setup
In the menu Search setup you can set the antenna power and the country in which you live.
Country:
Antenna Power:
6.2.2 Auto search
After selecting this menu item and pressing ok you will be asked to enter the PIN code (DEfAUlT
PIn: 0000) in order to update the current channel list. If you don't want to perform a full channel
scan you can press ExIT to cancel. After entering the PIN code (DEfAUlT PIn: 0000) the receiver
will perform an automatic channel search through all frequencies and after finishing this process it
will update the channel list. During the search process the receiver will display the progress bar, the
currently scanned frequency and the channel names. The receiver will add all new found channels
to the channel list.
6.2.3 manual search
In this menu you can search for channels on a specific frequency or channel. This menu requires
knowledge of some parameters in order to search on the correct channel/frequency in your area.
Scan mode:
If you set the scan mode By Channel, then the following is available:
Band:
Frequency channel:
If you set the scan mode By Frequency, then the following is available:
Frequency:
12
the LCN method will allow you to save the strongest channels
broadcasted in your area, only.
The channels will be sorted in alphabetical order.
The channels will be sorted in ascending order of the frequency
in which they are broadcasted.
The channels will be sorted by the operator ID.
The Delete all function will permanently delete all of the stored channels
and settings from your receiver!
Use the tu buttons to change the country.
If you use an antenna that can be amplified (i.e. an active indoor/
outdoor antenna) and it requires a voltage of 5 V and doesn't consume
more than 60 mA, then you can set the antenna power to On. If you use
an antenna without an amplifier or your antenna is already amplified
by an external power supply or if you use an antenna from a house
distribution system, please keep the antenna power Off.
Use tu to choose between By Channel and By Frequency.
Use tu to choose UHF (Ultra High Frequency) or VHF (Very High
Frequency).
Select a frequency channel on which you would like to search for
the channels.
Use 0-9 to enter the frequency on which you would like to search
for channels.
PART 2 • English