Accessories; Usage Of External Usb Devices; Your Receiver; Front Panel - Strong SRT 8525 User Manual

PART 2 • English
This manual provides complete instructions for installing and using this receiver. The following
symbols will serve as follow:
WARnIng:
noTE:
mEnU
(bold Characters)
Move to
(Italic Characters)

1.4 Accessories

Receiver - 1 pc.
„ „
User Manual - 1 pc.
„ „
Remote control - 1 pc.
„ „
Batteries (AAA) - 2 pcs.
„ „
WARnIng:
If rechargeable accumulators instead of batteries are going to be used, we recommend using (e.g.
NiMH) types with low self-discharge to ensure long time operation of remote control.

1.5 Usage of external Usb devices

It is recommended to use USB 2.0 storage devices. If your device is not compatible to USB 2.0
„ „
specifications, the multimedia and video playback with your receiver would not work properly.
If you are going to use external USB HDD (Hard Disk Drive) please consider that it might be
„ „
the case that the power specifications exceed the supported output of your receiver (5 V/500
mA). If so, please connect your USB HDD to a corresponding external power adapter.
STRONG cannot guarantee compatibility to all types of USB storage devices.
„ „
It is advised not to store important information on USB storage devices used with
„ „
the receiver. Always make backups of data on your USB storage device before using
it with this receiver. STRONG will not take responsibility for any loss of information or
circumstances caused by loss of information.
Please ensure that the USB device is already formatted to FAT/FAT32 or NTFS. If it is not,
„ „
please format the USB device via your PC or notebook.

2.0 YoUR RECEIvER

2.1 front panel

q button:
1.
2. stand-by indicator: Green light in operating mode and red light in standby mode.
3. Infrared sensor:
slot for smart card: The slot is behind the front flap and only intended for service use,
4.

2.2 Rear panel

1. AnT In
2. AnT oUT
Indicates warning information.
Indicates any other additional important or helpful information.
Represents a button on the remote control or the receiver.
Represents a menu item within a window.
The batteries should not be recharged, disassembled, electrically short-
circuited, be mixed or used with other types of batteries.
Switches the receiver between standby (off ) and operating mode.
Receives signals from the remote control.
it won't be used during operation.
To connect to your aerial using a standard antenna cable.
To connect to your TV or additional receiver via a standard
antenna cable.
Fig. 1
Fig. 2
3