Installing The Batteries; Using The Remote Control; Connection; Connecting To A Terrestrial Antenna - Strong SRT 8205 User Manual

20. FAV
21. MEDIA
22. 7
23. 
24. 5
25. USB
26. 8
27. 2
28. 6
29. COLORED BUTTONS

2.5 Installing the batteries

Open the cover on the remote control and insert 2x AAA batteries into the compartment. Correct
position of the polar diagram shows the batteries inside the compartment.
1. Open the cover.
2. Insert the batteries.
3. Close the lid.
WARNING:

2.6 Using the remote control

To use the remote control, point it towards the front of your receiver. The remote control supports a
range of up to 5 meters distance to the receiver at an angle of up to approx. 30 degrees.
NOTE:

3.0 CONNECTION

3.1 Connecting to a terrestrial antenna

To receive broadcasted signals, your terrestrial indoor or outdoor antenna must be connected to
the RF IN connector on the back of the receiver. Use a properly shielded antenna cable and suitable
connectors.
The RF OUT connector allows you to loop the antenna signal to a second receiver or TV set.
Please consider that the looped signal might be too weak if you use an active antenna.
Opens the favourite group selection
Enters to the list of records
Change media le to previous
Starts/resume playback of records and media les
Fast rewi nd playback
Opens the Media Player Video list
Change media le to next
Pauses playback
Fast forward playback
For Multimedia and Teletext functions
The batteries should not be recharged, disassembled, electrically short-
circuited, be mixed or used with other types of batteries.
Managing the receiver will be limited or not possible if there are obstacles
between the remote control sensor (at the front panel of the receiver)
and the remote control. Direct sunlight or very bright light can reduce or
disturb the reception of the remote control signals.
Fig. 4
Fig. 5
Fig. 6
7