Technical Specification - Strong SRT 8525 User Manual

PART 2 • English
Problem
Message "No The channel is scrambled.
rights" or "Pay
TV channel"
Not possible Batteries are exhausted/wrongly
to control the inserted.
receiver with Receiver powered or switched off.
the remote Remote not aimed correctly.
control
IR sensor obstructed/disturbed.
The IR sensor is covered up by
some object (obstacle between
RCU and receiver).
The receiver is switched off.
Forgot your
PIN code
The receiver Auto standby function enabled.
switches off
automatically.

8.0 TEChnICAl sPECIfICATIon

Tuner
Input connector:
Input frequency range:
Input signal level:
Antenna power:
Demodulation Dvb-T/T2
Demodulation:
Demodulation modes:
Bandwidth:
FFT mode:
Guard interval:
Forward Error Corrections:
video decoder
Profile:
Input bit rate:
Aspect ratio:
Frame rate:
Video resolution:
Possible reason
IEC60169-2, female, 75 Ohm nominal
VHF: 177.5 ~ 226.5 MHz
UHF: 474 ~ 858 MHz
-82 ~ -25 dBm
5 V DC (+/- 0.5 V), max. 60 mA, short cut protected
Compliant to DVB-T (EN 300 744), DVB-T2 (EN 302 755)
QPSK, 16/64/256 QAM
7 or 8 MHz
1K, 2K, 4K; 8K, 16K, 32K and extended normal
DVB-T: 1/32, 1/16, 1/8, 1/4;
DVB-T2: 1/128, 1/32, 1/16, 19/256, 1/8, 19/128, 1/4
DVB-T: 1/2, 2/3, 3/4, 5/6 7/8;
DVB-T2: 1/2, 3/5, 2/3, 3/4, 4/5 5/6
MPEG-2 MP @ ML, MP @ HL, MPEG-4 H.264/AVC
Up to 30 Mbit/s
4:3 and 16:9, Letterbox, Pan & Scan, Auto
25 Hz for PAL
576p, 720p, 1080i, 1080p
Remedy
Either you have tuned to a channel which
is not part of your subscription or you have
not been patient enough to wait until the
channel of your basic subscription has
opened. If the problem persists, please
contact the support of your service
provider. Support contact information can
be found in the enclosed brochure.
Replace the batteries/check the correct
polarity.
Plug in/turn on the receiver.
Point your remote towards the front panel.
Check for obstructions, other possible
influence.
Remove obstacles between RCU and
receiver.
Turn the receiver ON.
Consult your local dealer
Disable/adjust auto standby. See chapter
6.3.4 for details.
21