Strong SRT 8525 User Manual page 17

HDMI Output:
Loop out in stand-by:
Digital audio:
If neither your TV set nor any other connected audio equipment support decoding AAC and AC3,
adjust RAW HDMI OFF.
6.3.3 Time setting
This menu allows you to specify the method which the receiver will use to synchronise the date and
time and you can set the duration for displaying the information banner.
Time Offset:
Region:
Time Zone:
Summer Time:
Banner Time OUT:
6.3.4 Auto standby
Auto standby is a new feature that helps you reduce power consumption. When Activation is set to
On, the receiver will switch to standby if it hasn't received any commands for three hours. Set Auto
Standby to Off to deactivate this function. When the setting is On you can adjust the Duration Before
Standby: Available settings are: 1 Hour - 12 Hours with steps of one hour.
6.3.5 Parental Control
After selecting this menu item and pressing ok you will be asked to enter the PIN code (DEfAUlT
PIn: 0000). This menu allows you to use the EPG based parental rating system if supported by the
local broadcast.
Age:
Example: Your youngest child is 7 years old and you have set a rate of 07. Now when you switch
to a channel which is not foreseen for an age below 10 years you will have to enter the PIN code
(DEfAUlT PIn: 0000).
6.3.6 Reset factory Default
This option allows you to reset the receiver to the factory settings, which clears all stored channels
and settings.
14
about the possibility to control the TV format via the menu of
your TV set.
Allows you to change the resolution of the HDMI output. If the
connected TV does not support the set resolution you will see a
black screen. In this case, wait for 10-15 seconds without pressing
any buttons on the remote control of the receiver, and the
previous value will be recovered automatically.
This allows to by-pass the antenna signal to the ANT OUT
connector, where you may have an additional TV set/receiver
connected, in order to receive analogue/digital broadcasts there
too.
Use tu to adjust this setting in accordance to the used audio
equipment. To loop the digital audio through HDMI or S/PDIF to
a connected amplifier, home theatre or other equipment able to
decode AAC and AC3, set RAW HDMI ON.
Use tu to choose Auto to synchronise time and time zone
automatically, or Manual to specify the time zone manually.
Use tu to choose your specific country.
This setting is only available when the Time Offset is set to
Manual. You can use tu to adjust the time zone, if the automatic
settings in your region are not supported by the broadcast.
Use tu to select On or Off according to your local season.
Use tu to choose between the available settings: 3s, 4s, 5s, 6s, 7s,
8s, 9s and 10s.
Use tu to change the settings. Following rates are available: OFF
(to disable the function), 04, 05, 06, 07, 08, 09, 10, 11, 12, 13, 14, 15, 16,
17 and 18. Whenever switching through channels which submit EPG
based parental rate and the rate of the current broadcast is below
the adjusted rate, you will have to enter your PIN code.
PART 2 • English