Introduction; Safety Instructions; Storage; Equipment Set-Up - Strong SRT 8525 User Manual

1.0 InTRoDUCTIon

1.1 safety Instructions

Do noT InsTAll YoUR RECEIvER
In a closed or poorly ventilated cabinet; directly on top of or under any other equipment;
„ „
on a surface which might obstruct the ventilation slots.
Do noT ExPosE ThE RECEIvER oR ITs ACCEssoRIEs
To direct sunlight or any other equipment that generates heat; to rain or intense
„ „
moisture; to intense vibration and to any shock which may cause permanent damage to
your receiver or to any magnetic objects, such as loudspeakers, transformers, etc.
Do not use a damaged power cord. It may cause a fire or an electric shock. Do not touch a
„ „
power cord with wet hands. It may cause an electric shock.
When the receiver is not used for a long period of time, you should unplug the power
„ „
cord from the wall socket.
Do not use alcohol or ammonia based liquids to clean the receiver. If you wish, you
„ „
may clean your receiver with a soft lint-free cloth slightly made damp with a mild soap
solution, only after disconnecting from the mains voltage supply. Make sure no foreign
objects fall through the ventilation slots because this could cause fire or an electric shock.
Do not place any objects on top of the receiver because this might prevent proper
„ „
cooling of the components inside.
safety Precautions
Never open the receiver cover. It is dangerous to touch the inside of the receiver due
„ „
to high voltages. Opening the receiver will void the warranty of the product. Refer all
maintenance or servicing to suitably qualified personnel.
When you are connecting cables, be sure that the receiver is disconnected from the
„ „
mains supply voltage. Wait a few seconds after switching off the receiver before you
move the receiver or disconnect any equipment.
It is a necessity that you only use an approved extension and compatible wiring that
„ „
is suitable for the electrical power consumption of the installed equipment. Please
ensure that the electrical power supply corresponds with the voltage on the electrical
identification plate at the back of the receiver.
If the receiver does not operate normally, even after strictly following the instructions in this user
manual, it is recommended to consult your local dealer or contact the appropriate service.

1.2 storage

Your receiver and its accessories are stored and delivered in a packaging designed to protect
against electric shocks and moisture. When unpacking it, make sure that all the parts are included
and keep the packaging away from children. When transporting the receiver from one place to
another or if you are returning it under warranty conditions, make sure to repack the receiver in its
original packaging with its accessories. Failing to comply with such packaging procedures could
damage the product and void your warranty.

1.3 Equipment set-up

We recommend you consult a professional installer to set up your equipment. Otherwise, please
follow the instructions below:
Refer to the user manual of your TV and your antenna.
„ „
Make sure that all the connections, cables and outdoor components are in a good
„ „
condition and all the connections are well shielded and from good quality. We
recommend using high quality HDMI cables at least corresponding to HDMI 1.3 standard.
2
PART 2 • English