Records - Strong SRT 8525 User Manual

After your settings have been made, you can leave the menu with ExIT.
6.4.2 Information
In the Information menu you can get information about the hardware and software version installed
in your receiver. Furthermore, you will find information about our website: www.strong.tv. Please
open this menu when you call our hotline or contact the support. The person who answers your
call/email might ask for the information given on this screen.
6.4.3 Change Password
In order to access certain functions of the receiver you need to enter a PIN code. This is done to prevent
changes of the receiver settings through persons who do not know the PIN code (e.g. children).
To change the PIN code to a personal one it is required to enter your old (current) PIN (DEfAUlT PIn:
0000) by using 0-9 to enter it, and then to enter the new PIN code and confirm it again in below.
6.4.4 Updating the software by Usb
This feature allows you to upgrade receiver software via the USB port. If new software is available for
your receiver, it can be downloaded from our website www.strong.tv.
Place the software file (unzipped) into the root directory of your USB storage device (HDD, memory
stick etc.) and insert this device into the USB port of the receiver. Please consider that only USB devices
formatted in FAT or FAT32 file system will be detected and can be used for the update process.
Now select Upgrade by USB via the pq buttons and press ok to proceed. If the USB device is
detected successfully, you will be asked to enter your PIN code (DEfAUlT PIn: 0000). The receiver
will start the update process now and the progress information will be shown. Please wait until the
update is finished! After the update has been completed, the receiver will reboot automatically.
WARnIng:
6.4.5 software update via terrestrial signals
Your receiver can update software via digital terrestrial broadcast as well. You can find out via your
local support or dealer whether there is a new software version broadcasted in your area.
When you know that there is an update available, enter the menu OAD Upgrade in the Tools menu
and press ok to continue. The further steps will be shown on screen. Please read the instructions
carefully to update your receiver successfully!
During the update, a progress banner will be displayed for your reference.
WARnIng:
6.4.6 Remove the Usb device
This menu item only appears if a USB device is connected. Select the menu item and press ok to
remove the USB device from your receiver safely. Now you can disconnect the USB device after the
message USB device is removed disappears.

6.5 Records

Press mEnU and use tu to select Records, then press ok. Following submenus will be displayed:
Records List, Record Setup, Format and Remove USB device.
Use pq to select a submenu and press ok or u to access.
16
shown where you can press ok to confirm deletion or ExIT if you
wish to keep the timer.
After the update the receiver restarts automatically! During this process
NEVER disconnect the receiver from the main, the USB device or switch
the power OFF! This can damage your receiver and warranty will void!
During the update process NEVER disconnect the receiver from the main,
switch the power OFF or disconnect the antenna cable! This can damage
your receiver and warranty will void! After the update has been finished
the receiver restarts automatically!
PART 2 • English