Picture; Channel Search - Strong SRT 82 User Manual

NOTE:

7.4 Picture

Use this menu to match your receiver to your TV set.
The following settings are available:
Aspect Ratio:
Auto
16:9 widescreen
16:9 Pillarbox
16:9 Pan&Scan
Resolution
576p:
720p:
1080i:
1080p (50 Hz):
Auto:
TV Format

7.5 Channel Search

Auto Search
Manual Search
Country
Antenna Power
Scan Mode
For successful editing of channel list (see ch 7.1), switch Off LCN function.
Select the aspect ratio that matches your TV. The options are:
In most cases this default setting should suffice, but it can be changed to
cope with broadcast errors or personal taste.
A 4:3 programme will be show full screen, with sideways stretched content.
A 4:3 programme will be shown normally, but with black bars to the left and
right.
A 4:3 programme will be shown as a centre blow up to fill the whole screen,
missing content to the left, right, top and bottom of the programme.
If the video quality does not appear correctly, change the setting. These
settings match the most common settings for HDMI.
For digital SD TVs (some digital TVs do not support this mode).
For digital HD TVs (on HDMI connection).
For digital HD TVs (on HDMI connection).
For digital HD TVs (on HDMI connection).
The best possible resolution available will be auto negotiated by between
TV and receiver ('handshake') when using a modern digital HD TV when
connected with an HDMI cable.
Options are PAL and NTSC. For European broadcasts, the TV format is PAL
(Default).
This menu allows you to search for channels from all available frequencies
for your selected region automatically. Be aware that all previous installed
channels and favourite list(s) will be deleted. The new-found channels will be
installed in the channel list and afterwards you can create a new favourite list
if you like. Press OK to start the scan.
Select a particular channel to do a search on just one (known) frequency.
Press OK to start the scan. The signal quality bar might
check if the frequency is indeed in use.
Select the correct country where this receiver is used. If failing to do so, may
result in that channels appear randomly in the channel list, instead of a more
logical order.
Set to On if you use an active antenna. When set to On, 5 V will be present at
the RF in connector of the receiver. Select Off for passive antennas.
Select between FTA (Free-To-Air), which will only install Free-to-Air channels
or All, which will install all found channels, even if they are scrambled. Then
select Auto Search or Manual Search and press OK to start scanning.
be useful to
13