Call Tracing; Placing Conversation On Hold /Interrupting; Conversation /Terminating A Call 2-Line - TIPTEL 195 Operating Instructions Manual

Telephone calls

Call tracing

(Service has to be activated by your local telecommunications company.)
You receive an "unwanted" call and want to trace the calling party although the calling telepho-
ne number was not presented via CLIP.
1. Press the speed dialling station next
to the call displayed (e. g. "analog" or
"unknown".)
2. Press the speed dialling station next
to the display "tracing".
Placing conversation on hold/interrupting conversation
You can place a call on hold. While a conversation is on hold you can make an enquiry in the
room or even make an enquiry call. The party placed on hold cannot listen to the enquiry con-
versation. You can place up to 4 calls on hold. In addition, this function is used for a 2-line ope-
ration with hold, three-party conference and call transfer.
a) Hold:
1. Press button.
R
2. Press R button again.
b) Switch to second connection via the
speed dialling stations:
1. Press the speed dialling station next
to the display of the active connec-
tion.
2. Press the speed dialling station next
to "further connection".
Terminating a call
If you want to disconnect an established line.
1. Press the speed dialling station next
to the display of the line in question.
2. Press the speed dialling station next
to the display "disconnect".
A selection menu is displayed.
The calling telephone number is stored in the
exchange office. The corresponding subscri-
ber information can be obtained by your local
telecommunications company on demand.
The call is held in the exchange and the cal-
ler listens to an announcement. The display
for this call is shown in reverse. You may now
make an enquiry in the room or dial the target
telephone number to switch to an additional
line (see two-line operation with hold).
The connection with your initial line is re-esta-
blished.
A selection menu is displayed.
The line is held. You can now enter the target
telephone number to switch to an additional line.
A selection menu is displayed.
The line is disconnected. Replace the handset
now or if you are holding more than one line, con-
tinue conversation with one of the active lines.
25