Digital-Analog Cross Mode Setting - Icom IC-FR5000 Series Sales Handbook

Repeater Setting Repeater Setting
Repeater Setting Repeater Setting
1. Frequency and operation mode setting
Analog Repeater
RX = f0 TX = f2
Operation Mode ＝Simplex
Digital Repeater
RX = f1 TX = f3
Operation Mode ＝Repeat
2. CH Type and CTCSS/DTCS setting
Analog Repeater
CH Type = Analog CH Type = Analog
Necessary to setup when using CTCSS/DTCS.
Digital Repeater
CH Type = Mixed-Digital
3. AF Min Level setting
Digital-Analog Cross mode -Setting
← AF Min Level = 0 is
inhibit Audible output
mode therefore set
AF Min Level = 1
4. External I/O Port Setting
5-1. CTCSS setting
When using CTCSS of the Analog repeater.
Analog Repeater
▒ Note: Note: Digital Repeater setup is not required.
Note: Note:
▒ Note Note: In order to add CTCSS to the modulation input
Note Note
▒ from the D-SUB 25pin, TX C.Tone setting is necessary
▒ on top of the Multiple table setting.
5-2. RAN setting
When using RAN of the Digital repeater
▒ Note: Note: Analog Repeater setup is not required Note: Note:
Digital Repeater
41