Connecting The Scanner To A Power Supply - GRAPHTEC CS500 User Manual

3. PREPARING TO OPERATE THE SCANNER

3.2 Connecting the Scanner to a Power Supply

Note: Drawings of the CS500 model are used for the explanations.
Connecting the Power Cable
Insert the female plug of the power cord provided into the scanner's AC line inlet and insert
its male plug into an electrical socket supplying AC voltage.
Check that the scanner's Power switch remains in the Off position until the connection of
both the power cord and the interface cable has been completed.
Ensure that the scanner's Power switch is in the Off position.
Make sure that your scanner is properly grounded. If it is not grounded, there is a
possibility that noise will cause incorrect operation, or that the scanned image may
be distorted.
3 – 2 CS500/IS200