GRAPHTEC CS500 User Manual page 75

Image scanner
Hide thumbs Also See for CS500:
Table of Contents

Advertisement

Item
Document size
Effective scanning area
Guaranteed scanning
3
precision range*
Document thickness
Optical resolution
Interpolated resolution
Main scanning system
Sub scanning system
2
Scanning speed*
3
Scanning precision*
Gradation
Threshold value
Light source
4
Interface*
Output
Rated power supply
Operating environment
Power consumption
External dimensions
(approx.)
Weight
*1 Documents up to approximately 16 m in length (driver software limitation) can be scanned. However, the actual document length that
can be scanned is limited by the available memory (hard disk or other data storage device) of the computer to which the scanner is
connected, and also by the grade of the medium being scanned.
*2
Excluding data-transfer time
The following system was used to measure the scanning speeds.
CPU: Pentium 3.2 GHz or bette
The scanning speeds may be slower depending on the PC system used.
*3 Notes on scanning precision
Scanning precision may vary slightly depending on the grade and thickness of the medium being scanned, and on the operating
conditions. The precision figures above were measured under the operating conditions described below.
• Test chart used : Mylar sheet #200
• Guaranteed precision conditions : Temperature 20 ±3°C; humidity: 60% ±10% RH
• Document hold-down unit setting : Standard
*4 The USB 2.0 interface cannot be used at the same time as the IEEE 1394 or the Ethernet interface.
IS200-11/IS200-11eN/IS200-11PRO/IS200-11eN-PRO
ANSI E to ISO A4
Maximum width: 1090 mm; minimum width: 210 mm
Width : 1016 mm (centered)
1
Length : 16 m*
841 mm x 1189 mm
1.5 mm or less (including the carrier sheet)
600 dpi
IS200-11, IS200-11eN
IS200-11PRO, IS200-11eN-PRO
Contact image sensor system (Five A4 sensors in a zigzag pattern)
Document travel (sheet through) system
High-speed scan
Monochrome : 8s
Gray
: 22s
±0.1%, ±5 pixels
Monochrome: Bilevel, intermediate tones (dithering, error diffusion)
Gray: 256 shades
Digital signal processor enables automatic setting of the threshold value
(monochrome scans only)
LED
IS200-11, IS200-11PRO
IS200-11eN, IS2000-11eN-PRO
Image data
100 to 120/200 to 230 VAC ±10%, 50/60 Hz
Temperature: 10°C to 35°C
Humidity: 35% to 80% RH (non-condensing)
135 VA or less (60 W or less)
1205x957x715 mm (WxHxD)
(including stand)
Approx. 40 kg (including stand)
Memory: 1 GB or more
Interface: USB 2.0
: 50 to 800 dpi, in 1-dpi increments
: 50 to 4800 dpi, in 1-dpi increments
Normal scan
Monochrome : 13s
Gray
: 25s
: USB2.0, IEEE1394
: USB2.0, 10BASE-T/100BASE-TX

Advertisement

Table of Contents
loading

This manual is also suitable for:

Is200

Table of Contents