GRAPHTEC CS500 User Manual page 41

For Windows XP
The following procedure assumes that you are using the CS500-11 as part of your system,
and that you are using the USB interface. If you are using the IEEE 1394 interface,
GRAPHTEC CS500-11 IEEE 1394 SBP2 Device will be displayed where CS500-11 is
displayed when the USB interface is used. The scanner name displayed in the windows
is the name of the scanner connected to the computer (CS500-11 is used in this section).
(1) Connect the scanner to the computer, turn on the scanner first, and then turn on the
computer. When Windows starts up, insert the CD-ROM supplied with the scanner in
the CD-ROM drive. Turn on the power to the scanner.
(2) [Next], the Found New Hardware Wizard window appears.
Select the option "Install from a list or a specific location (Advanced)".
(3) The screen shown below is displayed when you click [Next].
Select the option "Search for the best driver in these locations" and select the check
box entitled "Include this location in the search".
Click Browse and select the DRIVER folder in the CD-ROM drive or enter a CD-ROM
drive name and \DRIVER using the keyboard.
Example: For drive E, enter "E:\DRIVER."
CS500/IS200
3. PREPARING TO OPERATE THE SCANNER
3 – 17