GRAPHTEC CS500 User Manual page 22

Control panel
POWER
PAPER
ERROR
SCAN
FORWARD
REVERSE
STOP
CS500/IS200
POWER LED
Unlit : Is unlit while the scanner is turned off.
Lit (green) : Lights when the scanner is turned and remains lit
Flashing (orange) : Flashes when the scanner is in power-saving mode.
PAPER LED
Unlit : Normal status (Local status).
Lit (green) : Lights when the scanner enters Scan READY status.
Flashing (green) : Flashes while image data is being scanned.
ERROR LED
Lit (red) : Lights to indicate a hardware error.
Flashing (red) : Flashes when a document is detected during the self-
Unlit : Normal status
( * When "Confirm" has been selected for the End-of-paper Processing setting
in the Scanning Master 21+ driver.
SCAN key
This key enables you to scan a document according to the settings of
Scanning Master 21+ when the scanner is connected to a computer.
Start up Scanning Master 21+ before scanning a document if it is not
already active.
FORWARD key
Advances the document into the scanner. When this key is pressed
in Scan READY status, the Scan READY status is cancelled and the
document is ejected toward the rear of the scanner.
REVERSE key
Feeds the document toward you. When this key is pressed in Scan
READY status, the Scan READY status is cancelled and the document
is ejected toward the front of the scanner.
STOP key
Compulsorily stops scanning of the document.
while it is operating normally.
test when the scanner is turned on; when scanning
is suspended by pressing the STOP key; when a
paper jam is detected; or when the document length
is shorter than the specified scan length.*
2. PREPARATION
)
2 – 9