GRAPHTEC CS500 User Manual page 49

4. LOADING A DOCUMENT
There are two document setting modes available (set by the driver
POWER
software).
PAPER
ERROR
• The rollers start turning at a preset delay time after the document has
SCAN
• The rollers start turning when the FORWARD switch on the control
FORWARD
Press the REVERSE switch to eject the document in order to reload it.
The PAPER LED lights up when a document is correctly loaded.
REVERSE
STOP
If the PAPER LED does not light after the document feed operation has stopped, press
the FORWARD key to advance the document again.
• After the scanner is turned on and the driver settings have been enabled in the
Scan window, it waits for approximately three seconds before beginning the specified
scan operation.
• Load the document in the scanner with the face to be scanned facing downward.
• Do not place anything other than the document to be scanned on the scanning table,
as the scanner rollers may start rotating, which is extremely dangerous.
• The document may not be fed in correctly if it is curled. The carrier sheet provided
should be used for curled documents (see Section 4.6, "Using the Carrier Sheet"
for details).
• Load the document in the center of the scanner, as the document may be fed in
at an angle and not scanned correctly if it is significantly off-center.
4 – 4
been inserted so that they automatically feed the document to the
position to start scanning.
panel is pressed after a document is inserted so that they automatically
feed the document to the position to start scanning. (Manual loading)
CS500/IS200