Placing The Scale; Quick Start - Cardinal PD150 Owner's Manual

Placing the Scale

Place the scale on a flat, level floor or low cut carpet away from any
rapidly moving air source (heating and cooling vents).
Check to make certain the scale is level. The level indicator is
located at the rear of the scale. If the scale is not level (the bubble
will not be centered), loosen the locking ring on all four (4) feet and
adjust them as required to center the bubble and attain a level
scale. Once the scale is level, lock the feet in place by tightening
the adjustment locking rings against the bottom of the scale.
IMPORTANT! Any time a scale is moved or re-located, be sure to check the level
bubble to make sure the scale is level before using.

Quick Start

Step 1. Once the scale is assembled, place it on the floor.
Step 2. Carefully lay the scale over on its side with the edge of the display resting on the
floor and then locate the battery access cover on the bottom of the scale.
Step 3. Remove the cover, install six (6) "AA" size batteries
Step 4. Return the scale to the upright, normal operating position and make sure it is level.
Step 5. Press the ON/OFF key to turn the scale on.
Step 6. When the display is showing 0.0, have to patient step on the scale.
Step 7. Wait a few seconds for the weight to display and then read the patient's weight.
Step 8. Patient may now step off scale.
Step 9. Press the ON/OFF key to turn the scale off.
1
See page 21 for detailed instructions on installing the batteries.
2
For complete Operation and Setup instructions, refer to pages 23 to 40.
16
PD350
0044-M380-O1 Rev A ProDoc BFA Series
NOT LEVEL
1
and then replace the cover.
2
LEVEL