Body Fat And Total Body Water Estimation With Digital Height Rod - Cardinal PD150 Owner's Manual

Body Fat and Total Body Water Estimation
1. Press ON/OFF key.
2. The display will turn on, show all digits, the software version for a few seconds and then a
small o is shown and moves across the display until a stable zero is established.
3. Next, after establishing zero, the scale will show 0.0 on display.
4. Press and hold PRINT/UNITS key to toggle between kilograms and pounds. The kg or lb
annunciator will turn on to show which weighing unit is active.
NOTE: Changing the units between kilograms and pounds will also change the height
measurement between centimeters (cm) and feet/inches ( ' / " ).
5. Make sure the height rod is in the starting position.
IMPORTANT! The digital height rod must be returned to its "starting position"
before every use (the inner sliding tube must be down completely inside the
outer stationary tube) and the headpiece folded flat against the stationary tube.
Otherwise, ----- will be displayed.
6. Patient may now step on scale.
7. Press MODE/ENTER/HEIGHT key.
8. Grasp height rod at hinge pin (see Figure No. 28) and raise it
well above patient's head and then lift headpiece to horizontal
position.
9. Carefully lower height rod until headpiece rests on top of
patient's head.
10. Press MODE/ENTER/HEIGHT key.
11. The display will change to the BFA mode (BFA annunciator will
be flashing).
12. Press MODE/ENTER/HEIGHT key.
13. The display will change to show the AGE prompt.
14. Using the numeric keys, enter up to 2 digits for the patient's
age and press the MODE/ENTER/HEIGHT key.
15. The display will change to show the GENDER selection
16. Press the RECALL or
MODE/ENTER/HEIGHT key.
17. The display will change to show the Normal (N) or Athlete (A) Mode selection.
18. Press the RECALL or
MODE/ENTER/HEIGHT key.
19. While the patient is still standing on the scale, the display will show a measurement pattern
while computing.
20. When the computation is complete, the body fat percentage, total body water percentage,
muscle mass percentage and bone mass percentage will be shown on display in sequence.
32
OPERATION
STORE keys to select the gender and press
STORE keys to select the Normal or Athlete Mode and press
0044-M380-O1 Rev A ProDoc BFA Series
with Digital Height Rod
Figure No. 28
(male) or (female).